Archive for the ‘Fabrication’ Category

Building the Motor Adapter

Sunday, September 14th, 2008

Decided to go clutch-less so will build an adapter using a keyed shaft coupler and the splined hub from the old clutch plate. Steve welds and machines the coupler.

The finished coupler used 1/4″ plate with spacers.

This SimpleViewer gallery requires Macromedia Flash. Please open this post in your browser or get Macromedia Flash here.
This is a WPSimpleViewerGallery

Posted in Fabrication | No Comments »

The Motor Arrives

Sunday, September 14th, 2008

The Warp 9 arrives at Steve’s place,. We begin building the coupler. Decided to go clutch-less so will build an adapter using a keyed shaft coupler and the splined hub from the old clutch plate.

This SimpleViewer gallery requires Macromedia Flash. Please open this post in your browser or get Macromedia Flash here.
This is a WPSimpleViewerGallery

Posted in Fabrication | No Comments »