«
»

Building the Motor Adapter

Decided to go clutch-less so will build an adapter using a keyed shaft coupler and the splined hub from the old clutch plate. Steve welds and machines the coupler.

The finished coupler used 1/4″ plate with spacers.

This SimpleViewer gallery requires Macromedia Flash. Please open this post in your browser or get Macromedia Flash here.
This is a WPSimpleViewerGallery

This entry was posted on Sunday, September 14th, 2008 at 2:42 pm and is filed under Fabrication. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

Leave a Reply

You must be logged in to post a comment.